Reason Your Tractor Won’t Turn Over and 5 Solutions

|

Tractors won’t turn over can be irritating for tractor owners. You need to start your tractor badly. You turn on the ignition switch, but unfortunately, the tractor refuses to turn over. But how can you solve this problem?

To solve the problem of the tractor not turning over, you first need to check your tractor’s battery. Sometimes, the battery connection becomes loosened, or the entire battery is damaged. Furthermore, you should also check the safety switches in your tractor to see whether they are misplaced. 

Luckily, if you follow the proper troubleshooting steps, you can fix the issue comprehensively. But, first, what you have to do is to read this entire article carefully. 

Why Won’t Tractor Turn Over? 

Why Won't Tractor Turn Over

No matter what type of tractor you have, the issue of a tractor can’t turn over is caused by quite a few reasons. You should have a decent idea about the causes to fix the problem as soon as possible. 

However, the possible causes are:

  • Loose battery connection/dead battery.
  • Faulty safety switches.
  • Bad starting solenoid.
  • Faulty fuel filter.
  • Defective engine.

5 Solutions For Tractor Won’t Turn Over

In the previous section, you came to know the possible reasons why the tractor can’t turn over. However, multiple issues can occur at the same time. That’s why it’s good to check all the issues. 

Once you are pretty sure about what causes the problem, our step-by-step guide below can help you a lot. 

1. Loose Battery Connection/Dead Battery: Check and Replace

Loose Battery Connection/Dead Battery: Check and Replace

A loose battery connection in your tractor is one of the common facts. However, if there is no proper electrical connection, the power transmission from the battery to your tractor’s engine becomes difficult.

Moreover, it will be more likely that the entire battery will be dead for some reason. Whatever the scenario is, you need to solve the issues as immediately as possible. 

Nevertheless, to solve the problem regarding battery, you should first check the battery connections. If they are loose, tighten them. Sometimes, the battery connection becomes corroded. Check and fix it as well.

Then, you should check the battery. The battery is damaged if you hear a clicking noise after starting your tractor. Replace the battery in this case. 

To replace your tractor’s battery, you may need to spend approximately $150-$300. However, the cost depends on the type of battery and the hours it takes to perform the task. 

2. Faulty Safety Switches: Check, Clean, or Replace

Faulty Safety Switches

Safety switches for any tractor play a prominent role. But, they can sometimes become loose, out of place, or damaged. And, in most cases, people discover the problem of the tractor can’t turn over because of the issue with the safety switch.

In a regular tractor, you will find safety Switches in different body parts. However, one of the most crucial safety switches is located under the driving seat of your tractor. Furthermore, you will find other safety switches underneath your tractor. 

When discussing fixing safety switch issues, first, you should check the wires of the safety switches. The cables may become loose, dirty, or corroded. In this case, you should clean the switches first and tighten the connection. 

Sometimes, the safety switch is knocked out of place, and you need to place them in the correct position. 

Additionally, if you find additional damage to the switches, there’s no alternative but to change them as soon as possible.  However, it is better to take your tractor to the mechanic to check and solve the issue with safety switches. 

If you need to replace the safety switches in any case, it won’t cost you more than $30 to buy the part. Hare, you have to include the labor cost as well. 

3. Bad Starting Solenoid: Replace

Bad Starting Solenoid

The main duty of a starting solenoid is to transfer voltage to the starter motor. That’s why if the starting solenoid can’t perform as expected, it won’t make the engine run properly. 

But unfortunately, the starting solenoid of your tractor may sometimes become faulty. Nevertheless, a blown fuse in the started circuit often causes the issue of a bad starting solenoid.

However, the first step in fixing the issue of a bad starting solenoid is to check it properly. Once you are pretty sure about the failure of a bad starting solenoid, it’s time to replace it. 

In most cases, repairing a failing solenoid won’t work. In addition, when installing a new starting solenoid for your tractor, make sure you choose the most appropriate one. Installing the wrong solenoid won’t provide you with any real benefit.

If you want to replace the bad starting solenoid with a completely new one, it will cost you around $80-$300 based on your tractor type. But, if you need to go with the mechanic, you must bear the labor cost of between $150-$500. 

4. Faulty Fuel Filter: Clean or Replace

Faulty Fuel Filter

A fuel filter in your tractor should function properly. However, if it becomes faulty due to additional debris or dust, it can’t deliver fuel to your tractor’s engine. And for this, the engine can’t start. 

However, problems with the fuel filter can make the entire fuel system of your tractor malfunction. 

Therefore, to solve the faulty fuel filter issue, you must first clean it to remove additional dirt and vents. This will help you get a clogged-free fuel filter that allows fuel to travel to the engine.

Furthermore, this may also happen that too much dirt can make the fuel filter faulty entirely. Though you never want this to happen, there’s no way rather than replace the fuel filter. 

But how much money do you need to spend to replace the fuel filter of your tractor? Well, you may need to spend around $50-$180 to replace the fuel filter. 

5. Defective Engine: Replace

Defective Engine

You are living in the paradise of a fool if you think you expect a proper turn over of your tractor having a defective engine. The importance of an engine for any tractor is needless to say. Unfortunately, however, the engine of your tractor can become defective sometimes. 

However, it is always better to repair the engine than replace it if you are sure it is damaged. But you can’t put a random engine to your traction. For this, you need to know what type of engine is suitable. 

The replacement cost of your tractor’s engine may seem a bit costly to you. However, you have to replace it if you don’t want to face the tractor engine won’t turn over the issue. 

It is more likely to cost you around $10,000-$15000 to replace the engine on your tractor. Furthermore, the labor cost for this replacement will be $1000-$1800.

FAQs About Tractor Not Turning Over Issue

Here, we have picked up some relevant and most asked questions regarding tractor can’t turn over. You may have a quick look to have a clear idea about your tractors turning over issue.

What Happens When a Solenoid Goes Bad?

The starting solenoid of your tractor transfers electric current from the battery to the starter. If the solenoid of your tractor goes bad, you won’t be able to start your tractor when you turn on the starter switch. 

Why Does My Tractor Battery Keep Dying?

For several reasons. As time progresses, the battery of your tractor loses its performance by reducing charge and may keep dying. Furthermore, additional leakage can also be a prominent cause of the battery problem.  

What Would Cause a Diesel Tractor Not to Start?

A faulty or damaged battery is the possible reason you can’t start your traction. Additionally, issues with the fuel filter can cause problems on some occasions. However, a failing engine is another common reason that causes a diesel tractor not to start. 

How Do I Know if My Tractor Fuel Pump Is Bad?

If it worsens, you will find starting or operating your tractor more challenging. Moreover, there is also a high possibility that possibly that the fuel economy of your tractor is dramatically reduced. 

Conclusion

Nothing to worry about regarding the tractor won’t turn over if you know how to fix it. And in this case, this troubleshooting article can help you a lot.

No matter what tractor you have, the possible causes and fixes will remain almost the same. 

Therefore, you just need to find the cause and then move forward to fix it. Furthermore, ensure you have the necessary equipment to check and fix the causes. 

However,  if you don’t have the equipment and think you can fix the problem, it’s always better to go with the professionals. 

Related Posts:

Similar Posts